Flue gas oxygen analyzers: WDG 1200 / 1210 / INSITU

Flue gas oxygen analyzers with Modbus communication

Ametek Thermox WDG 1200-1210 Flue Gas Oxygen Analyzers

The WDG 1200 / Insitu and the WDG 1210 / Insitu are rugged, reliable flue gas oxygen analyzers for net oxygen that use industry-proven zirconium oxide sensor technology. The outer probe tube is 310 stainless steel so no abrasion shield is needed for most applications. The controller features precision temperature control for optimum stability, built-in diagnostics, and over-temperature protection. Modbus interface and 4-20 mA outputs are standard. The unique sensor design allows the entire sensor assembly, including the heater, to be removed without disturbing the outer protection tube which remains in the process. This makes field service fast and easy, and because there is no need to return the probe to the factory for repair, there’s no expensive downtime.

Insitu Probe 
Accuracy (O2)±1% of measured value or ±0.05% oxygen, whichever is greater
ResponseCal Gas <3 seconds; process <20 seconds (63% of step change)
Drift<0.1% of cell output per month (less than 0.005% O2, per moth with 2% O2 applied)
Linearity±1% of output span
Repeatability±1% of output span
Max. Flue Gas Temp1472ºF (800ºC)
EnvironmentIndoor/Outdoor Use
Ambient Temp: -5ºF to 160ºF (-20ºC to 71ºC)
Relative Humidity: 10% to 95%, non-condensing
Probe Lengths9″ (0.23 m), 18″ (0.45m), 36″ (0.9m), 72″ (1.8 m), 108″ (2.7m)
EnclosuresNEMA 4X/IP65
Adobe PDF Reader

Ametek Thermox WDG 1200-1210 Flue Gas Oxygen Analyzers PDF

WDG 1200 / 1210-HPII Explosion proof Division 1

Ametek Thermox WDG 1200-1210 -HPII XP Flue Gas Oxygen Analyzers

Explosion proof Division 1, convective analyzers for direct measurement of oxygen in flue gas streams up to 1537°C. The WDG 1200 / 1210-HPII XP analyzers mount directly on the combustion process and are designed for direct measurement in flue gas applications without the need for installing a high temperature bypass system, a requirement on most petrochemical insitu analyzer applications. The elimination of the high temperature bypass system with the direct convection measurement of the WDG 1200 / 1210-HP XP analyzer insures a faster analyzer response to process changes and reduced installation cost by direct process flange mounting and no need for instrument air for sample transport or purge. These analyzers are suitable for gas streams up to 1537°C and for corrosive gas streams with sample wetted parts in Hastelloy® or Inconel®. The analyzers can be provided with integral on-board electronics (WDG- 1200-HPII XP) or a remote mount control unit installed up to 300m from the sensor (WDG-1210-HPII XP). Analog current output and MODBUS communication are provided for process measurement and communication.

Adobe PDF Reader

Ametek Thermox WDG 1200-1210 -HPII XP Flue Gas Oxygen Analyzers PDF